Ok, refresh my memory, in case it has been discussed already. I'm fixing to put an Offenhauser 4 barrel manifold and a Holley 4150 390cfm on my 65 Barracuda, 225/6, 904 transmission
I've been all over the net on the subject and looked at what is offered by the retailers for throttle linkage. Very confusing. (of course I'm "old" and working on two Barracuda projects at the same time, doesn't help) I'm a fabricator by trade, but I'm sure there is a "plug and play" application, to keep me from having to "engineer" some. Any suggestions?
Norm

Hey there Circlepilot,
I’m not at all familiar with the ‘Cuda set-up, but when i upgraded my pickup to a Super Six with a Motorcraft 2150, i used Summit’s throttle cable kit. They have kick down cable kits also in case your transmission is of the automatic variety.

_________________
1975 Dodge D100 225 c.i., HEI, Parallel Offenhauser, Motorcraft 2150, 904 auto, 9.25" 3.55:1

Thanks for the information...I looked at the Summitt kit, I'll have a look at it again.

I noticed you are located in Pauls Valley...I was there late Summer 2016 and picked up my second 65 Barracuda. I bought it off of a young man that worked as an EMT there. I remember his house was located about a block or so from a rail road that seemed to go through the middle of town.
Norm

You can also use a later model (67-76) Dart/Duster pedal and cable.

_________________
Official Cookie and Mater Tormentor.

Thanks