Slant Six Forum
https://slantsix.org/forum/

Starter question
https://slantsix.org/forum/viewtopic.php?f=28&t=62419
Page 1 of 1

Author:  dirtyd100 [ Tue May 29, 2018 8:02 pm ]
Post subject:  Starter question

Doing a trans swap from a 903 3 speed to an 833OD. The 3 speed was set up with a low mount starter and I need to install a high mount starter for the 4 speed. What would be some recommendations for a new starter. I have seen everything from a V6 Dakota to a Hemi mini starter. Any suggestions would be great and the most frugal choice would be best.

Thanks

Author:  DusterIdiot [ Tue May 29, 2018 9:09 pm ]
Post subject:  Re: Starter question

1992 Dodge Dakota Starter V-6 or V-8 is the easiest 'cross reference'.

These are typically about $35 tops at local junkyards and fit all common high mount starter applications...

Author:  dirtyd100 [ Thu Jun 14, 2018 6:02 pm ]
Post subject:  Re: Starter question

Thanks again DI, do I need to remove anything from this starter as my truck has a relay for the starter? Thought I read something about this but can't seem to find it again.

Thanks again

Author:  DusterIdiot [ Thu Jun 14, 2018 6:26 pm ]
Post subject:  Re: Starter question

Is it a relay or solenoid? The 10 tooth starter equipped vehicles had the relay, and no mods needed... the 9 tooth starter circuit will
need to change as the starter already has the solenoid...

Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/