Slant Six Forum https://slantsix.org/forum/ |
|
distributer conversion https://slantsix.org/forum/viewtopic.php?f=28&t=62796 |
Page 1 of 1 |
Author: | daisydodge [ Mon Sep 03, 2018 6:52 pm ] |
Post subject: | distributer conversion |
I have a 1983 dodge d-150 pickup 225 slant six manual transmission I had motor fully rebuilt bored 30 over and balanced, I pulled original holley 1 barrel carburator and installed offenhauser four barrel manifold and new holly 390 cfm carb . I have original distributer that tied into computer and original carb I have no vacuem advance I know that i probably need to shange out distributer for a earlier model and make some other changes electricly I live outside of deq and need to set up for performance any suggestions? |
Author: | Charrlie_S [ Mon Sep 03, 2018 10:24 pm ] |
Post subject: | Re: distributer conversion |
You need to post in the proper section of the site. |
Author: | and739 [ Tue Sep 04, 2018 9:23 am ] |
Post subject: | Re: distributer conversion |
Is yours the Lean Burn system? If so, there's an article on just such a conversion to EI on the Articles page. Here's a link: http://slantsix.org/articles/leanburn-a ... rticle.htm Good luck |
Page 1 of 1 | All times are UTC-07:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |