Slant Six Forum
http://slantsix.org/forum/

distributer conversion
http://slantsix.org/forum/viewtopic.php?f=28&t=62796
Page 1 of 1

Author:  daisydodge [ Mon Sep 03, 2018 6:52 pm ]
Post subject:  distributer conversion

I have a 1983 dodge d-150 pickup 225 slant six manual transmission I had motor fully rebuilt bored 30 over and balanced, I pulled original holley 1 barrel carburator and installed offenhauser four barrel manifold and new holly 390 cfm carb . I have original distributer that tied into computer and original carb I have no vacuem advance I know that i probably need to shange out distributer for a earlier model and make some other changes electricly I live outside of deq and need to set up for performance any suggestions?

Author:  Charrlie_S [ Mon Sep 03, 2018 10:24 pm ]
Post subject:  Re: distributer conversion

You need to post in the proper section of the site.

Author:  and739 [ Tue Sep 04, 2018 9:23 am ]
Post subject:  Re: distributer conversion

Is yours the Lean Burn system?
If so, there's an article on just such a conversion to EI on the Articles page. Here's a link:
http://slantsix.org/articles/leanburn-a ... rticle.htm
Good luck

Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/