Slant Six Forum

Dodge w150 flywheel inspection cover
Page 1 of 1

Author:  87dodgeW150 [ Wed Sep 11, 2019 6:59 pm ]
Post subject:  Dodge w150 flywheel inspection cover

Hi all,

I am new to this forum so I apologize in a advance if this post is mislocated. I am trying to track down a flywheel inspection cover (the large plate that bolts to the bottom of the bellhousing). Thus far I have had no luck finding the specific size needed. The truck has a slant six with an np435. The bellhousing has four bolt holes. The front bolt hole spacing is roughly 16 5/8 which seems pretty typical with what is on eBay. However, the back spacing is about 13 3/8 inches. I have not had any luck finding this combo.

Page 1 of 1 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited