Does anyone if these look correct for a 62 Lancer? My engine sits right on the K member but these are what came with the car.

[img][img]http://i1376.photobucket.com/albums/ah7/JohnnyDees/2017-04-19%20002%20003_zps2nrgmewl.jpg[/img][/img]

_________________
1966 Dart GT
4 spd. OD conversion
8 3/4 - 3.55 SG (Sold)

62 Lancer GT
B Body 8 3/4

They look like the ones on my 63 Dart, the one on the left side of picture is for the passengers side of the motor.

Richard

_________________
Part of Tyrde-Browne Racing

Yes, those are '62-'66 A-body Slant-6 engine mounts. Worn out ones; you need new. The part that gets replaced is the rubber block. These are the ones to get if you never want to have to replace them again.

_________________
一期一会
Too many people who were born on third base actually believe they've hit a triple.

Thanks for the replies,

_________________
1966 Dart GT
4 spd. OD conversion
8 3/4 - 3.55 SG (Sold)

62 Lancer GT
B Body 8 3/4

Thanks Dan

_________________
Hyper_pak

Hey Johnny.
Check out this link:
http://www.forabodiesonly.com/mopar/thr ... 032/page-6

I had an issue with mounts on my wagon. Maybe this applies to your installation.

_________________
Hyper_pak

Hey Johnny, I replied to your PM, but my replie is still sitting in my out box.
Charlie

_________________
Charrlie_S
65 Valiant 100 2dr post 170 turbo
66 Valiant Signet 225 nitrous
64 Valiant Signet
64 Valiant 4dr 170