Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to make a donation to the Slant Six Forum!
This is a "new" board. Click here for info.

It is currently Thu Nov 23, 2017 9:39 pm

All times are UTC-08:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Return line?
PostPosted: Sat May 06, 2017 6:19 pm 
Offline
TBI Slant 6
User avatar

Joined: Tue Feb 24, 2015 3:41 am
Posts: 215
Location: South Carolina
Is there a sending unit with return that will fit in my factory side mount or will I have to fabricate something? Any ideas or comments?


Top
   
 Post subject:
PostPosted: Sat May 06, 2017 11:51 pm 
Offline
Board Sponsor
User avatar

Joined: Sat Feb 08, 2003 2:37 pm
Posts: 4334
Location: CA
I brazed a nipple on mine. Later on I stumbled upon this idea I would have rather done. Drill/tap the filler neck for npt thread. Install hose barb, to hardline, through the trunk floor (or filler tube gasket?). Or could use an npt > flare fitting and flare the hardline if your worried about a rubber line leaking. Once your below the trunk floor you can use another section of hardlline to make install easier.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC-08:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited