Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum upgrade!
It is currently Sat Mar 28, 2020 2:12 pm

All times are UTC-07:00




Post new topic  Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Sat Jan 18, 2020 8:30 pm 
Offline
1 BBL (New)

Joined: Wed Aug 28, 2019 3:39 pm
Posts: 5
Location: Brooklyn Park, MN
Car Model*: 86 Dodge Ram D100
Pretty much all the engine compartment wiring on my truck is shot. The insulation is cracked on most all the lines.
I'm trying to get the connector at the bulkhead apart. No joy.
Is there some trick I'm missing? I unscrewed the center bolt, and I've been pulling on the housing but it wont budge.
Any ideas?

Thanks!


Top
   
PostPosted: Sat Jan 18, 2020 9:51 pm 
Offline
Supercharged

Joined: Wed Sep 17, 2008 6:48 pm
Posts: 2931
Location: Indianapolis
Car Model*:
It is possible that the terminals have corroded them selves together. However remember to transmit electrical current effectively there must be a tight fit between the male and female terminals.

I would get the nozzle of a good vacuum up to the engine side of the terminal block alternate with compressed air and dislodge the crud that you can. Then soak each terminal with penetrating oil, let it set over night and re peat the vacuum / air blow and try again to pull the block apart.

Repeat as necessary.


Top
   
PostPosted: Sun Jan 19, 2020 5:46 am 
Offline
1 BBL (New)

Joined: Wed Aug 28, 2019 3:39 pm
Posts: 5
Location: Brooklyn Park, MN
Car Model*: 86 Dodge Ram D100
So it sounds like there aren't any tabs or clips etc that are keeping it together, just 34 years of sitting.
Thanks!


Top
   
PostPosted: Sun Jan 19, 2020 6:30 am 
Offline
Supercharged

Joined: Wed Sep 17, 2008 6:48 pm
Posts: 2931
Location: Indianapolis
Car Model*:
Quote:
aren't any tabs or clips etc that are keeping it together,


not that I remember on my '83, that is what the bolt is for.


Top
   
PostPosted: Sun Jan 19, 2020 2:21 pm 
Offline
Supercharged
User avatar

Joined: Sun Nov 03, 2002 9:20 pm
Posts: 12460
Location: Fircrest, WA
Car Model*: 82 Ramcharger, 76 D100
Spray it down with a penetrating lubricant and let it sit overnight. Then gently work the connector back and forth until it comes free.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 5 posts ] 

All times are UTC-07:00


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited