Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Sat Jun 25, 2022 6:23 pm

All times are UTC-07:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Mon Apr 06, 2009 7:59 am 
Offline
Turbo Slant 6

Joined: Fri Feb 06, 2004 9:47 pm
Posts: 526
Car Model:
How critical is to have tight joint?

I can feel the play when I wiggle venturi when top is off but cannot remove it easily because of factory punch mark keeping venturi from coming out of carb's body.

If have to be fixed, there are options: I could either do o-ring but there a little issue and other option is drill and tap a thread and a set screw to push venturi sideways towards emulsion tubes and keep it secure with spot of threader locker.

I have a parts weber carb I take apart to learn on and discovered that there is no o-ring sealing and there is no room to create groove for a o-ring unless *rather* thin o-ring?

Comments?

Cheers, Wizard


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC-07:00


Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited