Slant *        6        Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Sat Jun 25, 2022 7:05 pm

All times are UTC-07:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Mar 25, 2009 10:20 am 
Offline
Board Sponsor
User avatar

Joined: Tue Jun 27, 2006 8:21 am
Posts: 1614
Location: Orlando, FL
Car Model:
As many know I am planning to change out the big cam and install a smaller one. I also have a MSD timing computer which lets me easily play with the timing curve. I am looking for some ideas of where I should start with the new cam. I'd like to reprogram the computer just prior to pull the motor/cam, so that its close during cam break in.
I am currently running 23* initial and 29* (all in at 3000rpm) total with no vacuum pod hooked up. (240/240@50 110 installed 2* advanced)

The new cam is a 222/222@50 110 installed 2* advanced.
Any ideas? Leave it for now?

CR 9.25

_________________
67Cuda,FAST EZEFI,340cu,CR=10.25,RollerCam&Rocker (XR268HR,#20-810-9)(#1622-16)(EddyRPM#60779,#7576), (MSD6AL,#6425) A904, GearVendorsOD, 8 1/4,3.55:1, ClassicAir
Image


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC-07:00


Who is online

Users browsing this forum: No registered users and 22 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited