Year One (M&H Harnesses) shows 1964 Dart harnesses but not 63. After looking at the '63 harness it look much different than later Mopars where they broke it out into 3 separate harnesses under the hood at the bulkhead. Anyone know if the bulkhead connector is the same between '63/'64. Maybe not the pin out put will they physically plug together?

Thanks.
Jim

That's a good question, as my '63 sure could use some new wiring. I am surprised Dan hasn't tackled this one.

_________________
“Buy the ticket, take the ride.”
― Hunter S. Thompson

Got a picture of the connector? Most of the connectors Mopars used at the time are Packard 56 series.

_________________
Matt Cramer
1966 Dodge Dart turbo / EFI project

Here is one on a stockish 64.

2 connectors not 3.


Greg

_________________
http://www.youtube.com/hyperpack

In that case, I suspect they're the 56 series. Del City is a a good supplier for small quantities, if a bit on the pricey side.

https://www.delcity.net/store/Packard-5 ... ors/p_9108

_________________
Matt Cramer
1966 Dodge Dart turbo / EFI project