Selling some bits and pieces I have accumulated over the years. Trying to make space for new projects. Pictures tomorrow.

Two mid A body 225 engine dipsticks and tubes.

One set power steering pump brackets for a slant.

Several alternator brackets, two a body, one F body, I think

Oil pump splash guards, about five of them

Factory cam and lifters, I think from a 1963 225

Another unknown factory cam

I have a box of oil pumps with no drive gears, all pulled from running motors, should be considered cores. Let me know if you know where to buy slant oil pump drive gears.

I will add more as I find and sort it.

Prices are best offer. Money is nice but space is nicer. I am happy to pass these parts along to someone who can use them.

You pick up from my garage in Tacoma, WA or pay shipping. I will ship usps flat rate when I can.

_________________
Casually looking for a Clifford hyperpak intake for cheap.

I'm looking for AC brackets if you run across anything in the stash

_________________
1970 Barracuda 225 /6, 3spd on the floor, Blue/Blue

Actually, I believe I have a complete AC system I pulled from a Duster in a junkyard about 20 years ago. It uses the older V-twin compressor, but I think I have everything- compressor, condenser, under-dash evaporator unit, everything but the hoses and receiver/dryer. Shipping would be expensive, but I would sell the whole setup.

Let me know if you are interested and I will dig it out of my attic.

_________________
Casually looking for a Clifford hyperpak intake for cheap.

I plan on installing a vintage air unit on my e-body, so I only need the brackets.

_________________
1970 Barracuda 225 /6, 3spd on the floor, Blue/Blue

OK, I will check and see if my memory is accurate. I haven't touched the boxes in years and need to make sure I am remembering correctly.

_________________
Casually looking for a Clifford hyperpak intake for cheap.