Quote:
I still like this one: http://dansby.net/slant/ohc.jpg
whats what i was thinking...but a picture to...so its been done 
| Slant Six Forum https://slantsix.org/forum/ |
|
| Any interest in an aftermarket head? https://slantsix.org/forum/viewtopic.php?t=15468 |
Page 2 of 2 |
| Author: | Reed [ Fri Dec 23, 2005 7:28 pm ] |
| Post subject: | |
skraeken- that IS an interesting setup. It looks like it uses a flywheel driven camshaft. That would solve some of the issues with connecting an overhead cam. |
|
| Author: | 1966 dart wagon [ Sat Dec 24, 2005 4:24 pm ] |
| Post subject: | |
Quote: I still like this one: http://dansby.net/slant/ohc.jpg
whats what i was thinking...but a picture to...so its been done
|
|
| Author: | skraecken [ Sun Dec 25, 2005 4:38 am ] |
| Post subject: | |
Yep, about 30 years ago. |
|
| Author: | slantzilla [ Sun Dec 25, 2005 5:12 am ] |
| Post subject: | |
Quote:  Here a Picture of something me and the boys cobbled together 1 weekend. I had to piece together 2 chains to reach the slant crank snout....run the stock EI off a short chunk of the old cam. We used a stock Super Six manifold and BBD. You have to make 2 studs longer. I used a stock Chev v8 thermostat housing which fit the upper rad house perfectly. Id say most folks could put this together in an afternoon for less than $300. Send me $50. 
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|