Slant Six Forum
https://slantsix.org/forum/

Rockers, the upslope?
https://slantsix.org/forum/viewtopic.php?t=28028		 Page 2 of 2
Author:  Doc [ Tue Mar 25, 2008 9:34 am ]
Post subject: 
The info. listed says it's a forged crank engine.
DD
Author:  Rob Simmons [ Tue Mar 25, 2008 10:59 am ]
Post subject: 
Quote:
http://www.rockerarms.com/#TOP

Rocker Arm Specialists. Last set I bought were $85 plus freight and they did not want any cores back. Quality is very good, they have been on my motor on all my low 12 second passes. :D
I just tried to find the listing for their aluminum roller rockers and couldn't find it... Hmmm
Author:  slantzilla [ Wed Mar 26, 2008 6:34 am ]
Post subject: 
Quote:
I just tried to find the listing for their aluminum roller rockers and couldn't find it... Hmmm
They may have quit making them again. Production seems to be spotty on them at best. :shock:
Author:  SlantSixDan [ Wed Mar 26, 2008 6:39 am ]
Post subject: 
F: 1970 model year (means it's a forged-crank, solid-lifter engine)
225: Engine displacement
T 11: Doesn't parse. You sure that "T" is a "T"? You should either have a digit in place of the "T", or you should have four digits after the "225".
Author:  Rob Simmons [ Wed Mar 26, 2008 6:55 am ]
Post subject: 
Quote:
Quote:
I just tried to find the listing for their aluminum roller rockers and couldn't find it... Hmmm
They may have quit making them again. Production seems to be spotty on them at best. :shock:
It's all good. Seymour hooked me up. :wink: We're gonna be lookin' for around 300HP without none of them "Bamboozlers" on this next one! :shock:
Page 2 of 2 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/