| Slant Six Forum https://slantsix.org/forum/ |
|
| Welding to the cast manifolds???? https://slantsix.org/forum/viewtopic.php?t=28855 |
Page 2 of 2 |
| Author: | Adams_65_valiants [ Fri May 30, 2008 4:26 pm ] |
| Post subject: | |
heh, sounds kinda like what I did with my exhaust.... kinda but not really close at all. I had a crack all the way around the manifold and had to weld it back together with a stick welder (all I had access to) and the flap inside the manifold never worked very well after that so I just welded it in place. takes a bit longer to warm the carb up enough to idle without the manual choke I rigged up but it works very well. I also saw a 2 mile per gallon increase in efficiency after that too. |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|