Where's the seam on the piston rods?
| Slant Six Forum https://slantsix.org/forum/ |
|
| Cats out of the bag!!!! rods and pistons are ready!! https://slantsix.org/forum/viewtopic.php?t=31558 |
Page 2 of 2 |
| Author: | emsvitil [ Tue Oct 14, 2008 2:33 am ] |
| Post subject: | |
Where's the seam on the piston rods?
|
|
| Author: | mopardemon71 [ Tue Oct 14, 2008 8:23 am ] |
| Post subject: | |
I would hit up Brain and see if he has a piston with a dish already. I dont think it's thick enough for what you want. The piston dia. is 87.50 So if you find one (in metric) you can just ask for a .901 pin. I'll see if I can measure it. |
|
| Author: | mopardemon71 [ Tue Oct 14, 2008 8:31 am ] |
| Post subject: | |
the rods are way sick!!!! I am just a little bummed they don't have the K1 on the beam like the web site ones  . They say K1 on the arp bolts though and my friend says their going to be inside the engine so who cares.
|
|
| Author: | mopardemon71 [ Thu Oct 16, 2008 8:33 am ] |
| Post subject: | |
wow dead thread. Well to correct myself the compression height is 1.625. |
|
| Author: | Dart270 [ Thu Oct 16, 2008 9:57 am ] |
| Post subject: | |
I have called Brian about 6 times and left one message. Hopefully I can order these sometime soon and they're not already sold out. I'm sure he is a busy guy... Thanks again, Lou |
|
| Author: | Volare4life [ Thu Oct 16, 2008 2:19 pm ] |
| Post subject: | |
gorgeous pistons and rods, wish I had the money now to get them. Is there any kind of time frame to order these ? is it a limited run or can I get them when ever ? -Mike |
|
| Author: | mopardemon71 [ Fri Oct 17, 2008 5:50 pm ] |
| Post subject: | |
Lou email him. Trust me it works better than calling him. His email is bnutter@wiseco.com. Last time i spoke with Tom at K1 he had a predelivery of like 10 sets of rods and the rest would come in soon. As far as I know they will have them in stock but ask to make sure. |
|
| Author: | darrt wells [ Sat Oct 18, 2008 4:40 pm ] |
| Post subject: | |
hey sorry if this sounds dumb, but can someone fill me in on the these rods and pistons? What is so important about em ? |
|
| Author: | Volare4life [ Sat Oct 18, 2008 5:53 pm ] |
| Post subject: | |
http://slantsix.org/forum/viewtopic.php?t=29565 read this -Mike |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|