Looking at video Motor is running backwards :shrug: But other than that it's great
| Slant Six Forum https://slantsix.org/forum/ |
|
| measurement question https://slantsix.org/forum/viewtopic.php?t=34895 |
Page 2 of 2 |
| Author: | Draginslant [ Mon Mar 01, 2010 1:56 pm ] |
| Post subject: | |
Of course, no other forum would understand, aside from being impressed with what the project entailed. The block was done in Inventor, but it wouldnt be hard to get you a CAD file, cause thats one of the mediums we use at school. Been busy gettin ready for this final for the project, so After thursday should have enough to show. BTW, do I need to be a paying member to share pics? |
|
| Author: | Draginslant [ Mon Mar 01, 2010 1:58 pm ] |
| Post subject: | |
No, they did not. They got a "Hemi-6" engine starting in '70 that was all iron, never aluminum. There is now an aftermarket company producing an aluminum Hemi-6 head -- very costly. There is no interchangeability between the slant-6 and Hemi-6 head or other components. Didnt know this, but thanks for the heads up. |
|
| Author: | Draginslant [ Fri Mar 05, 2010 9:40 am ] |
| Post subject: | |
After alot of stress My group and I finally gave our slant six presentation... Everyone was very impressed. Although, after looking it over, I see flaws that would keep the parts from being actually made, but its all little changes. If someone drops me an email Ill send them the AVI of a cut away view of the entire setup rotating, dont know how to post it up or I would |
|
| Author: | Draginslant [ Sat Mar 06, 2010 1:25 pm ] |
| Post subject: | |
http://www.youtube.com/watch?v=scOt8yinyw0 here it is on youtube for anyone who wants to see it |
|
| Author: | adiffrentcity [ Sat Mar 06, 2010 7:33 pm ] |
| Post subject: | |
Looks nicely done! Congratulations on your follow-through and I hope you continue to use your skills for the benefit of the slanters. |
|
| Author: | 66aCUDA [ Sun Mar 07, 2010 4:44 am ] |
| Post subject: | |
Great Job!!! Keep on Slanting/ Frank |
|
| Author: | Draginslant [ Fri Mar 19, 2010 5:56 pm ] |
| Post subject: | |
thanks guys... gunna see about talking to a company like scat to see if I can get a custom crank, off of a similar design... Fingers crossed |
|
| Author: | Fopar [ Fri Mar 19, 2010 8:02 pm ] |
| Post subject: | |
Looking at video Motor is running backwards :shrug: But other than that it's great
|
|
| Author: | Draginslant [ Mon Mar 22, 2010 12:48 pm ] |
| Post subject: | |
eh, might be, we were on a time crunch to get a rotation made, it was good enough for an A for our group, so guess no one else noticed 
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|