That looks lean and mean, low and not too slow.
| Slant Six Forum https://slantsix.org/forum/ |
|
| flipping rear spring hangers https://slantsix.org/forum/viewtopic.php?t=36008 |
Page 2 of 2 |
| Author: | AnotherSix [ Fri Jul 03, 2009 11:38 pm ] |
| Post subject: | |
Both sides are the same. I heard the swap sides when flipping hangers story but it just isn't how it works. One thing I ran into on our 71; I was installing new leafs with the later, large spring eye and the spring eye just touched the body with the stock hangers flipped over. I could have hammered on it but I went with aftermarket hangers instead and used the center hole. The height is right where I want it. |
|
| Author: | green1970 [ Sat Jul 11, 2009 9:21 am ] |
| Post subject: | |
i got it done a while back but haven't had time to post. i love where it sits and the pinion angle seems to be ok too. i didn't flip the shackles from side to side as they are identical. i just used some uni-bits and made the holes a little bigger. it wasn't all that bad and it was free! can't complain there. thanks for all the help everyone. |
|
| Author: | green1970 [ Sat Jul 11, 2009 9:32 am ] |
| Post subject: | |
here's a pic of how it looks now. http://i228.photobucket.com/albums/ee57 ... 2-1247.jpg |
|
| Author: | slantfin [ Sat Jul 11, 2009 8:13 pm ] |
| Post subject: | |
That looks lean and mean, low and not too slow.
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|