| Slant Six Forum https://slantsix.org/forum/ |
|
| Removing rods...problem. https://slantsix.org/forum/viewtopic.php?t=37135 |
Page 2 of 2 |
| Author: | CudaViking [ Thu Sep 17, 2009 6:57 pm ] |
| Post subject: | |
I dont know that much, I know it came from a Dodge van, and has been sitting outside for quite some time. But I mean, I work in auto glass and my bosses buddy is a mechanic genius and he gave me this motor for free. I figure since I have a /6 cuda and started mechanic schooling this would be perfect to learn to rebuild on, beef it up a tad and do an easier swap out than to swap rear ends and all that good stuff for a v8. |
|
| Author: | dennisd4o [ Fri Sep 18, 2009 8:28 am ] |
| Post subject: | |
I admit the teardowns I described have been on big blocks. The pistons will come right out. |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|