That must be one heck of a gasket. I have never seen one so thick that the nuts won't fit on the studs!
Doug: "factory's fastener ast-uo"? I don't think I have one of those.
| Slant Six Forum https://slantsix.org/forum/ |
|
| 225 slant six manifold and exhust washers(conical)?? https://slantsix.org/forum/viewtopic.php?t=43892 |
Page 2 of 2 |
| Author: | SlantSixDan [ Wed Mar 09, 2011 6:58 pm ] |
| Post subject: | Re: Good Question DD |
Quote: I'm good to go except for the castle/conical fasteners
See here; put such a nut in a vise and give two or three of the castle "fingers" a love tap with a drift punch to create the kind of "gripper" interference thread Doc talks about above.
|
|
| Author: | easy803 [ Wed Apr 27, 2011 7:36 pm ] |
| Post subject: | |
I also have a interest in this as my exhaust manifold is leaking:( due to 3 small washers installed before I bought it |
|
| Author: | 61 V200 [ Wed Apr 27, 2011 8:33 pm ] |
| Post subject: | |
I pulled prolly 1/2 dozen at the salvage yards that took the stud out with it before I got one off with just the brass bushing attached. A little heat and a drift seperated the two. |
|
| Author: | Chuck [ Wed Apr 27, 2011 10:44 pm ] |
| Post subject: | |
That must be one heck of a gasket. I have never seen one so thick that the nuts won't fit on the studs! Doug: "factory's fastener ast-uo"? I don't think I have one of those.
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|