Slant Six Forum
https://slantsix.org/forum/

Help id this slant 6
https://slantsix.org/forum/viewtopic.php?t=48498
Page 2 of 2

Author:  chuck mcb [ Thu Apr 12, 2012 10:08 am ]
Post subject: 

Thanks Dan. When I get home I'll track down the number on the block.I think I should drop the oil pan and have a look-see. Maybe pull the head too but what do you guys think? I feel fortunate the engine is mounted on a stand complete with radiator which makes working on it a whole lot easier.

Author:  SlantSixDan [ Thu Apr 12, 2012 11:00 am ]
Post subject: 

What do we think about…what?

Author:  chuck mcb [ Thu Apr 12, 2012 11:15 am ]
Post subject: 

Dropping the oil pan and maybe pulling the head to see what's gone on inside it

Author:  SlantSixDan [ Thu Apr 12, 2012 11:50 am ]
Post subject: 

I would recommend rebuilding the 1960 engine, which has been sitting for decades and was in unknown-used condition when pulled.

Author:  chuck mcb [ Thu Apr 12, 2012 11:51 am ]
Post subject: 

Let the tear down began!

Author:  chuck mcb [ Fri Apr 13, 2012 12:36 pm ]
Post subject: 

This might be over already. Where the starter bolts on there is a piece of the block that appears to have torched off. It's one of the mounting points for the bell housing :cry: We didn't notice it until last night.

Author:  chuck mcb [ Tue Apr 17, 2012 6:12 pm ]
Post subject: 

I have not given up yet!

Page 2 of 2 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/