| Slant Six Forum https://slantsix.org/forum/ |
|
| Felpro vs Endurotec https://slantsix.org/forum/viewtopic.php?t=57046 |
Page 2 of 2 |
| Author: | SlantSteve [ Fri Feb 06, 2015 11:28 am ] |
| Post subject: | |
I realise the junkyards aren't full of slants these days to allow picking and choosing parts(if you thinks it's tough in the US then try over here),but I would be surprised if the factory bothered to selectively fit heads to blocks and check chamber alignment either and they seemed to get away with it and obviously used a standard gasket...admittedly on a Std bore...and no,I'm not suggesting to do just that on a rebuild,after all,that's why it's recomended to check the alignment during a rebuild so I appreciate there is an alignment issue. |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|