| Slant Six Forum https://slantsix.org/forum/ |
|
| Wiring removal for drag car https://slantsix.org/forum/viewtopic.php?t=5740 |
Page 2 of 2 |
| Author: | Charrlie_S [ Wed May 28, 2003 12:25 pm ] |
| Post subject: | |
You can call, up to about 11:00 pm. I'll be up later, but then we won't have much time. Where is the diagram Doc posted? I didn't see it. |
|
| Author: | Rob Simmons [ Wed May 28, 2003 1:25 pm ] |
| Post subject: | Late night! |
Hey Charrlie, I'll try to call as early as possible. I will try to get over there as early as 8-8:30. Doc posted a link to the electronic ignition wiring diagram in about the fourth reply to this original post. I think it is a link to one of the articles pages. I'm pretty sure my problem is an open circuit somewhere in the primary wiring, not necessarily the ignition circuit. Rob |
|
| Author: | Rob Simmons [ Thu May 29, 2003 5:03 am ] |
| Post subject: | Success!!! Thanks Charrlie!!! |
We have a running Duster again! Charrlie walked me through the wiring over the phone last night. One call to go over the basics, a follow up to say it didn't work and add one more wire, and a third call so he could hear it run! Thank you so much Charrlie! You're right, it is pretty simple if you stay very basic and don't let the diagrams scare you! Now I've gotta hustle and get the myriad of other things done to get ready for Bristol. This Forum and the people that are involved Rock! 7 days 'til Bristol... Rob |
|
| Author: | Rob Simmons [ Sat Jul 16, 2011 5:49 pm ] |
| Post subject: | I've come full circle... |
Here it is more than 8 years later and I'm no smarter than I was then.  At least I used the search function to try and help myself first.  Now I'm thrashing on the second version of the GodsRods Duster and trying to figure out the basic wiring for the ignition, neutral safety switch and charging system yet again. Too bad GodsRods Duster I is all the way in Arkansas... 
|
|
| Author: | Rob Simmons [ Fri Jul 29, 2011 12:55 pm ] |
| Post subject: | |
I emailed Gerald a list of questions and he took the time to answer them all. He's a good mentor.  I made some progress on getting things wired the other night. 
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|