Fresh coat of JB weld and new paint
Ground the seams and other hot spots and three coats of header paint
Need to clean up a little paint that got around my mask job. Then just need to swap with the set that is on the truck
| Slant Six Forum https://slantsix.org/forum/ |
|
| Exhaust manifold swap https://slantsix.org/forum/viewtopic.php?t=57811 |
Page 2 of 2 |
| Author: | Hanibel [ Thu Jul 02, 2015 10:44 am ] |
| Post subject: | |
Should I fill with JB weld and then grind it down? Or should I grind the seams first and then JB weld? Or just coat with JB weld and leave it the way it is? Thanks in advance |
|
| Author: | Reed [ Thu Jul 02, 2015 11:47 am ] |
| Post subject: | |
I would coat it with JB weld until you have a nice smooth surface, then paint everything with a heavy coat of paint. |
|
| Author: | Hanibel [ Mon Jul 06, 2015 9:47 am ] |
| Post subject: | |
Fresh coat of JB weld and new paint Ground the seams and other hot spots and three coats of header paint Need to clean up a little paint that got around my mask job. Then just need to swap with the set that is on the truck |
|
| Author: | SlantSixDan [ Mon Jul 06, 2015 11:00 pm ] |
| Post subject: | |
Hanibel, that's nice work. Purple intake manifold = better driveability, performance, and more (s)miles per gallon. That's a scientific fact! 
|
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|