| Slant Six Forum https://slantsix.org/forum/ |
|
| Intake manifold overheating https://slantsix.org/forum/viewtopic.php?t=59215 |
Page 2 of 2 |
| Author: | mcknight505 [ Wed Mar 02, 2016 6:50 pm ] |
| Post subject: | |
Thanks I think I'm going to get a set of dutra duals where the rear manifold doesn't have the heat riser and looks similar to the front half then weld in a bung on the down stream side of the flange to pipe some heat up to the carb much like yours. Now I just need to find a set any suggestions? |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|