Slant Six Forum
https://slantsix.org/forum/

New to the List~1964 Dodge Dart Convertible question
https://slantsix.org/forum/viewtopic.php?t=59353		 Page 2 of 2
Author:  emsvitil [ Tue Mar 29, 2016 7:07 pm ]
Post subject: 
Bad Picture Links..............
Author:  ski [ Tue Mar 29, 2016 8:57 pm ]
Post subject: 
Your Dart is a beauty. Rims and tires look great. Can you post a pic of the area you're concerned about?

ski
Author:  wolfegang [ Tue Mar 29, 2016 9:40 pm ]
Post subject: 
Hi Ed... yes I had bad links, but they are corrected, go to page 1 of the
discussion, the pics are at the bottom of the page... Mike
Author:  wolfegang [ Tue Mar 29, 2016 9:41 pm ]
Post subject: 
Hi Ski.... yes I will take some picture tomorrow & show you the area that
concerns me... thanks! Mike
Author:  wolfegang [ Wed Mar 30, 2016 6:13 pm ]
Post subject: 
Hi Ski... Here's the pics of the tire clearance on my Dart. On the drivers side it's about 3/4 inch... less on the pass-side. I mean... the tires do not touch the
fenders at all... but would they say if I was cornering hard & braking? Lots 'o windy roads here in NH!!! Mike
Image
Image
Image
Image[/img]
Author:  ski [ Wed Mar 30, 2016 6:37 pm ]
Post subject: 
Yes.....maybe heat it up with a torch and bend or roll it in a bit?
Author:  wolfegang [ Wed Mar 30, 2016 7:22 pm ]
Post subject: 
Hi Ski, It will probably never hit... but rolling those very pointed ends in just
a tad... can't hurt. I would like to know what others on the list think? Thanks!
Mike
Author:  emsvitil [ Wed Mar 30, 2016 9:54 pm ]
Post subject: 
Sit on the fender and turn the wheel and see how close it gets.......
Author:  wolfegang [ Wed Mar 30, 2016 10:21 pm ]
Post subject: 
Good point Ed! Will do... I appreciate the advice! -Mike
Author:  wolfegang [ Thu Mar 31, 2016 4:44 pm ]
Post subject: 
Hi Ed... we tried your suggestion today, no change at all in clearance. Thanks!
Mike
Page 2 of 2 All times are UTC-07:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/