Slant Six Forum
https://slantsix.org/forum/

Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
https://slantsix.org/forum/viewtopic.php?t=63802		 Page 2 of 2
Author:  MotorHoggGears [ Wed Jul 10, 2019 10:12 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
Choke works
Author:  MotorHoggGears [ Wed Jul 10, 2019 10:14 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
On the ignition coil where is the condenser wire supposed to be
Author:  Reed [ Wed Jul 10, 2019 11:08 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
The little capacitor that is mounted on the coil is not the condenser. It is the noise suppressor for the AM radio. Leave it disconnected for now. I THINK it attaches to the - terminal , but if you connect it to the wrong terminal you can ground the coil and not have spark. Just leave it detached.
Author:  MotorHoggGears [ Thu Jul 11, 2019 8:29 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
So today I'm getting the bolt for the harmonic balancer but idk if it the right thread that I found on a forum. It was 3/4-16,2"1/4 long
Author:  MotorHoggGears [ Thu Jul 11, 2019 9:15 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
Which size is better 2 or 2 1/2 long cause that all the hardware store has? I want a bolt cause its way easier than bumping it.
Parts store has 3/4-16,2 and 3/4-16,2 1/2
But they have the washer 2" any ideas
Author:  Reed [ Thu Jul 11, 2019 9:59 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
Go for the 2 inch. An extra 1/2 inch might not fit and it won't give you any benefit over the 2 inch.
Author:  MotorHoggGears [ Thu Jul 11, 2019 10:04 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
So 2in long and what about the washer?
Author:  Reed [ Thu Jul 11, 2019 10:47 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
A thick washer should be used to sprea the load of the bolt.
Author:  MotorHoggGears [ Thu Jul 11, 2019 10:52 am ]
Post subject:  Re: Need help with my slant adjusting points and just good info..Never had a slant but this is living to it's name
Quote:
A thick washer should be used to sprea the load of the bolt.
A2in washer ok or bigger
Page 2 of 2 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/