| Slant Six Forum https://slantsix.org/forum/ |
|
| Fabricating an air dam. https://slantsix.org/forum/viewtopic.php?t=40704 |
Page 3 of 3 |
| Author: | Sam Powell [ Tue Jul 13, 2010 9:50 pm ] |
| Post subject: | |
I am thinking there might be something in the vinyl siding department that could be used here. It is flexible, tough, and the trim pieces come in a wide variety of shapes. And, it is not too expensive. Sam |
|
| Author: | madmax/6 [ Fri Jul 16, 2010 2:04 pm ] |
| Post subject: | |
This is my front end treatment. Bumper cover came out of the trash at my friends body shop. It's a Chrysler 2002 Pacific SUV rear bumper cover that I cut a few inches out of the middle and put back together. There is a little spoiler lip on the bottom. Guzzi Mark 
|
|
| Author: | Sam Powell [ Fri Jul 16, 2010 7:27 pm ] |
| Post subject: | |
Quote: This is my front end treatment. Bumper cover came out of the trash at my friends body shop. It's a Chrysler 2002 Pacific SUV rear bumper cover that I cut a few inches out of the middle and put back together. There is a little spoiler lip on the bottom. Guzzi Mark
Now you are talking. Very nice indeed!Sam |
|
| Page 3 of 3 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|