Slant Six Forum https://slantsix.org/forum/ |
|
Bent Intake Valves w/ Wiseco ProTru Pistons :-( https://slantsix.org/forum/viewtopic.php?t=39249 |
Page 4 of 4 |
Author: | Dart270 [ Mon May 25, 2015 6:58 pm ] |
Post subject: | |
I only did intake clearancing. It was less than 1/8" for sure, more like 0.040". I used play dough to mark it and then cut by eye. IIRC, my 1.76/1.46 valves did not hit the valve reliefs, but were very close around the edges (0.020" or so). Lou |
Author: | Greg Ondayko [ Mon May 25, 2015 7:09 pm ] |
Post subject: | |
I do believe it's mostly intake. 1/8 might be on the generous side. in this situation i would rather take off too much insted of not enough. I swiped a bit of the edge with a sharpie and ground until all the marker line was gone. Greg |
Page 4 of 4 | All times are UTC-07:00 |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |