I am building a slant 6 for the street, but I want it to be a strong street engine. I will use a Clifford 3X2 weber Intake, and 3 DCOE 40's. What I need is:
1. A set of headers that are compatible with the Clifford intake.
Clifford headers ARE NOT . Shorty headers are OK. If I can find A
set or have a set fabricated I would like to run a turbo.
2. A head that has been ported and machined for big valves
3. A set of high compression forged pistons, and moly rings
4. A roller cam set up, or a good flat tappet cam, rockers, springs etc.
5. Specs. on how much I can bore the block, mill deck, and mill the
head. (safely)
This engine will be the 225 variety, I will run a A833 4 Speed.