Slant Six Forum
https://slantsix.org/forum/

/6 Displacement Stamping
https://slantsix.org/forum/viewtopic.php?t=10294		 Page 1 of 1
Author:  72swing [ Wed Sep 01, 2004 6:39 pm ]
Post subject:  /6 Displacement Stamping
G/S everyone,

Anyone care to explain EXACTLY where the displacement stamping is on the /6? Pic(s) or detailed information would be Great... I am probably looking right past it but I did spend quite some time searching.

I have a block number of 2806830-2, which is The High Block, Forged Crank [RGFC], (From what the articles on this site say
Quote:
I feel that the "second generation" of RGFC blocks (2806830, 1968 – 75) are the strongest.
) the most desireable block for doing buildups :)

I want to make sure that it's not a 198, and if it is I'd like to find out exactly how to increase stroke.

As always, I'm fairly humble :oops: and any information is greatly appreciated.
Author:  moparfreak [ Wed Sep 01, 2004 6:46 pm ]
Post subject: 
it's up by the altinator on top of the block you should be able to see it with the head on it
Author:  72swing [ Wed Sep 01, 2004 7:03 pm ]
Post subject: 
GOT IT!!

A nasty bit of "life o the road" had gotten on the stamping flange and covered all trace of the lettters, Gum out + Elbow Grease = 225!!!

Thanks again,
Justin
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/