Slant *       6       Forum
Home Home Home
The Place to Go for Slant Six Info!
Click here to help support the Slant Six Forum!
It is currently Sat Nov 30, 2024 4:46 am

Unanswered topics | Active topics


» » Tech Q & A » Engine

All times are UTC-08:00



Post new topic  Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Print view Previous topic | Next topic 
Author Message
Ranch Guy
PostPosted: Sun Jan 30, 2005 5:57 pm 
What are the measurments for pre 68 crank hub and the measurements for the later crank so that at a junk yard I can measure to make sure I get the right one. Does clutch size make a differance? thank you. Ranch guy
Top
   
Reply with quote  
Dart270
 Post subject:
PostPosted: Sun Jan 30, 2005 7:00 pm 
Offline
Board Sponsor & Moderator
User avatar

Joined: Mon Oct 21, 2002 11:08 am
Posts: 16793
Location: Blacksburg, VA
Car Model:
The 68-up hub is 1.815" ID, 67-down is around 1.66". Can't remember ODs. Clutch size does not matter, but the flywheel centering holes will be different for the two crank hub sizes.

Lou

_________________
Home of Slant6-powered fun machines since 1988
Top
   
Reply with quote  
Display posts from previous:  Sort by  
Post new topic  Reply to topic  Page 1 of 1
  [ 2 posts ] 

» » Tech Q & A » Engine

All times are UTC-08:00

Who is online

Users browsing this forum: Bing [Bot], Charrlie_S and 15 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited