Slant Six Forum
https://slantsix.org/forum/

balancer wobbles
https://slantsix.org/forum/viewtopic.php?t=11660		 Page 1 of 1
Author:  zedpapa [ Sun Feb 06, 2005 6:17 pm ]
Post subject:  balancer wobbles
the balncers on my motor has been wobbling for about 4 years now and i am beginning to be bothered by it. i have looked all over and haven't seen any listings for one. i know a lot of V8 parts swap over to the slant. is there a V8 balancer that fits?

zedpapa
Author:  Pierre [ Sun Feb 06, 2005 6:40 pm ]
Post subject: 
Call up these folks, they rebuilt one of my dampners

Damper Dudes
5509 Cedars Rd # 2
Redding, CA 96001
(530) 244-7225

They do good work, just be careful and take a picture of what you give them. I had to return mine once because they put the timing mark in the wrong place (in relation to the keyway). Other then that they do quality work, was about $60 give or take.

Infact, if you want, I have a spare I got back from them that has been sitting collecting dust I can sell you.
Author:  SlantSixDan [ Sun Feb 06, 2005 8:17 pm ]
Post subject: 
Check the threads on this board; Damper Dudes' work has been...I'll just say "inconsistent".

There's a guy on eBay who rebuilds and sells \6 Dampers. I can't vouch for the quality of his work, but i did exchange e-mails with him and he was aware and articulate of the difference in timing mark between '63-'67 and '67-up slant-6 engines.
Author:  Pierre [ Sun Feb 06, 2005 8:26 pm ]
Post subject: 
Dealing with DamperDudes is a bit of a hassle I'll deffinately agree to that, but their work is good (or at least was when I dealt with them 5+ years ago when my dampers were done). So if you can find quality work elsewhere, deffinately go that route.
Author:  Doctor Dodge [ Sun Feb 06, 2005 11:12 pm ]
Post subject: 
I also have a pile of good used dampeners, drop me a PM if you need one.
DD
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/