| Slant Six Forum https://slantsix.org/forum/ |
|
| throw on throw out bearing https://slantsix.org/forum/viewtopic.php?t=12160 |
Page 1 of 1 |
| Author: | 6Tee9 [ Wed Mar 09, 2005 8:03 pm ] |
| Post subject: | throw on throw out bearing |
hi im building a t bucket with a hopped up slant 6 and a A-833OD tranny. I am wondering how far the throw out bearing needs to move to disengage the clutch and not go over center. I am useing a chevy master and slave cylinder out of a full sized truck. Any help would be very well appreciated. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|