Ive read all the articles about fuel injection. I have collected most of the parts for the 3.8 conversion with MAF. My question is could I use 2 - 2.8 throttle bodies from the speed density system. And integrate them into the 3.8 MAF system.? I have access to used throttle bodies cheap and I allready have the offy 2x 1 manifold.

_________________
1966 Dart GT
4 spd. OD conversion
8 3/4 - 3.55 SG (Sold)

62 Lancer GT
B Body 8 3/4

The problem here is that you would have to pass all the air through the MAF sensor first. I think if I were determined to use that manifold I would go with a Mega Squirt speed density set-up.
Bob D

Thanks Bob- No I am not determined to use the manifold, just weighing my options. I have a cast aluminum 1 barrel I might use with the 3.8 throttle body although it looks like a lot of cutting to open it up. or sell everything and get an offy. Decisions.......Decisions............

_________________
1966 Dart GT
4 spd. OD conversion
8 3/4 - 3.55 SG (Sold)

62 Lancer GT
B Body 8 3/4