| Slant Six Forum https://slantsix.org/forum/ |
|
| 135 2.2 turbo pistons question https://slantsix.org/forum/viewtopic.php?t=12971 |
Page 1 of 1 |
| Author: | Slant6Rat [ Fri May 13, 2005 6:00 pm ] |
| Post subject: | 135 2.2 turbo pistons question |
Whats the difference between the 84-85 2.2 turbo piston and the later 86-90 piston? They both seem to have a 1.573" compression height. Are the pin hole heights or pin sizes different? Would either work in a 225 long rod /6? |
|
| Author: | Doctor Dodge [ Sat May 14, 2005 9:17 am ] |
| Post subject: | |
On the Silvolite pistons I have used, piston material, piston dish size and pressed vs a floating piston pin were the differences. The turbo piston is the better unit but the bigger dish yields lower compression and should be set-up as a floating pin. More info and photos in the Stroking article. DD |
|
| Author: | Slant6Rat [ Sat May 14, 2005 11:54 am ] |
| Post subject: | |
Thanks Doc! The one's I'm thinking of are the Fed Mogul #532-P dish and the Fed Mogul #533-P circular dish with 2 reliefs. As far as I can tell these are the cast turbo pistons supplied to Chrysler by Mogul. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|