| Slant Six Forum https://slantsix.org/forum/ |
|
| 83 half ton pickup lowering https://slantsix.org/forum/viewtopic.php?t=14065 |
Page 1 of 1 |
| Author: | mrbillohnooo [ Wed Aug 17, 2005 11:22 am ] |
| Post subject: | 83 half ton pickup lowering |
I am wanting to do a 3 inch on the front and 6 inch rear drop on my 83 short wide pickup. does anybody sell dropped spindles for this application , or is there a car spindle that will obtain these results? I plan on doing a c-notch and putting the rearend above the springs...This vehicle is only for fun, wont be hauling anything in it...any comments on dropping one of these trucks would be helpful. I am aware that all the brake assemblies would need to be swapped to match the application also if using car spindles. Thanks! Bill |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|