| Slant Six Forum https://slantsix.org/forum/ |
|
| source for stock electrical connectors https://slantsix.org/forum/viewtopic.php?t=14821 |
Page 1 of 1 |
| Author: | sixsignet [ Tue Oct 25, 2005 11:34 am ] |
| Post subject: | source for stock electrical connectors |
Is there a source out there for electrical connectors for early 60s a-bodies? I need the T-shaped 2-conductor connectors for the single-speed wiper motor. I need the male and female. |
|
| Author: | mcnoople [ Tue Oct 25, 2005 1:13 pm ] |
| Post subject: | |
If you're not going for resto perfection just use any connector with the correct wire guage. Do you need the terminals or the plastic or both. |
|
| Author: | sixsignet [ Sat Oct 29, 2005 9:09 pm ] |
| Post subject: | |
I needed the plastic and the terminals. I found a set on an early 80s Toyota truck near the windshield washer reservoir. They fit the connectors for the 63 one-speed wiper. I just had to cut off the retaining clip. I used these connectors to plug my intermittent wiper control in-between the wiper motor and the original wiring harness. The T-shaped 2-conductor connectors they sell now have a wider gap between the two conductors and the plastic shell does not match the 63 mopar connector. |
|
| Author: | cavisco [ Sun Oct 30, 2005 8:08 am ] |
| Post subject: | |
Try waytekwire.com. They carry the packard 56 series connectors and terminals (pg 29 of there catalog) that were used on the old mopars. Next time you are at the pick n pull grab a harness or 2 from a late model crown vic or one of those huge suvs. Lots of good multi-colored wire in those beast and the insulation on the modern wire has a higher temperature rating than the old oem stuff used years ago. Invest in the correct crimp tool and solder each connection after crimping. I built a complete underhood harness for a '66 fury this way. Works great. Scott. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|