| Slant Six Forum https://slantsix.org/forum/ |
|
| Ball Joint Size fro D200 4X2 https://slantsix.org/forum/viewtopic.php?t=15071 |
Page 1 of 1 |
| Author: | Greg Ondayko [ Sat Nov 19, 2005 8:48 am ] |
| Post subject: | Ball Joint Size fro D200 4X2 |
Hi guys, I need to get the ball joint socket to remove the upper ball joints from my 77 d200. I searched online for the tool, but all that was listed / sold was one for a c body. I am guessing that this is the same size as my truck, but just want to check and be sure before purchase. Thanks for any help. Greg |
|
| Author: | volaredon [ Sun Nov 20, 2005 2:21 pm ] |
| Post subject: | |
There were actually 3 diffrernt sises of these over the years. the smallest was for A bodies (only) from '60 til around 66-67. Then there was the C body one which also fit B-vans and trucks, the most common one for cars was the "middle" one. I don't know if the older A body one is still being made, never had one myself. I do have the other 2, though. All of these I have seen are a 3/4" drive so you'll either need a 3/4 to 1/2 reducer adapter or a 3/4"drive ratchet/breaker bar. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|