I think you are looking for one of these:
You can find it on my products page.
| Slant Six Forum https://slantsix.org/forum/ |
|
| Heater for bottom of Manifold? https://slantsix.org/forum/viewtopic.php?t=15360 |
Page 1 of 1 |
| Author: | bwhitejr [ Mon Dec 12, 2005 5:08 am ] |
| Post subject: | Heater for bottom of Manifold? |
I would think it would help the fuel flash better if there was a heater attached to the bottom of the Offy or Clifford manifolds in a setup that uses headers. A machined piece where engine coolant is circulated through it. Has anyone made such a thing or know where to get one? bwhitejr |
|
| Author: | dart_swinger [ Mon Dec 12, 2005 7:03 am ] |
| Post subject: | |
I came across this guy's piece, that does just that, about a week ago. http://www.mergetel.com/~fraso/RasoEnte ... -Mopar.htm the part is about 2/3 of the way down the page, named "intake manifold heater kit" |
|
| Author: | FrankRaso [ Mon Dec 12, 2005 7:03 am ] |
| Post subject: | |
I think you are looking for one of these: You can find it on my products page. |
|
| Author: | DusterIdiot [ Mon Dec 12, 2005 7:06 am ] |
| Post subject: | Clifford and frank |
Clifford has a water heated manifold already cast (seen 'em)... Frank Raso did a really good job on his heater box. Since I have a "lot" of manifold, I use an exhaust heat box. (immediate heat, vs. heat about 5-10 minutes after your choke's pulled off). -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|