| Slant Six Forum https://slantsix.org/forum/ |
|
| Assine Valve Question https://slantsix.org/forum/viewtopic.php?t=15404 |
Page 1 of 1 |
| Author: | Josh [ Thu Dec 15, 2005 7:27 am ] |
| Post subject: | Assine Valve Question |
One would think that with all the time I spend lurking on this forum, that I might have figured this out on my own, but if I upgrade to bigger valves for my street 225, what would the installation entail, and which valves would be recommended. Can I do this in the shop without completely screwing it up? thanks, josh |
|
| Author: | Matadem [ Thu Dec 15, 2005 8:28 am ] |
| Post subject: | |
1.70/1.44 stainless from sivalves.com about $10 each |
|
| Author: | Greg Ondayko [ Thu Dec 15, 2005 8:44 am ] |
| Post subject: | |
SI - Check the link- http://www.slantsix.org/forum/viewtopic.php?t=15078 Probably best to have a shop handle cutting the valve seats in - Thoughts anyone? Greg |
|
| Author: | bwhitejr [ Thu Dec 15, 2005 8:59 am ] |
| Post subject: | Valve Question |
I second the SI Valve choice. I just put their stainless stock size valves in my rebuild. Very nice valves. Highly recommended. |
|
| Author: | Josh [ Thu Dec 15, 2005 9:01 am ] |
| Post subject: | |
So, what would go into putting the 1.70 1.44 valves in place of my stock valves? I'm worried that I may not be able to find a shop that can do it for me. |
|
| Author: | Rob64GT [ Thu Dec 15, 2005 9:40 am ] |
| Post subject: | |
Anybody that can do a good valve job shouldn't have a problem installing larger valves. This would be a good time to install hardened valve seats for the exhaust. |
|
| Author: | Josh [ Thu Dec 15, 2005 9:56 am ] |
| Post subject: | |
Awesome. I just called around and there's a shop right up the road from me that can do it all within my meager budget. Thanks for this info. |
|
| Author: | DusterIdiot [ Thu Dec 15, 2005 10:27 am ] |
| Post subject: | Cool... |
I have a set of those SI Valves the 1.70/1.44/... although they don't "look" much bigger, they are useable without a major over bore, they use a stock lock (no special keepers to buy), and the back cut on the stem is really nice... -D.Idiot |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|