Thanks, I needed that
| Slant Six Forum https://slantsix.org/forum/ |
|
| Slant six exhaust header flanges https://slantsix.org/forum/viewtopic.php?t=15786 |
Page 1 of 1 |
| Author: | Kevin Johnson [ Mon Jan 16, 2006 7:53 am ] |
| Post subject: | Slant six exhaust header flanges |
Charrlie called me yesterday about header flanges and I suggested that I post links to "free-ware" jpg and dxf files of a general design. These files can be taken to any jobshop using a water jet or laser cutter and produced. Crank scrapers and other windage control devices are really our thing and I wanted to make these files available as a small way to support the Mopar community. Kind regards, Kevin Johnson http://www.crank-scrapers.com/SL6_HEADER_FLANGE.jpg http://www.crank-scrapers.com/SL6_HEADER_FLANGE.dxf |
|
| Author: | MJF [ Mon Jan 16, 2006 12:35 pm ] |
| Post subject: | |
Thanks, I needed that
|
|
| Author: | Dart270 [ Mon Jan 16, 2006 1:07 pm ] |
| Post subject: | |
I will look into getting my local shop (Hamilton's in Raleigh) to make these reasonably. Lou |
|
| Author: | Tom Drake [ Mon Jan 16, 2006 1:42 pm ] |
| Post subject: | |
I have a water jet source if anyone is interested. I would need a pattern that you guys want...the one we use would not work. |
|
| Author: | sick6 [ Mon Jan 16, 2006 2:34 pm ] |
| Post subject: | |
as a former waterjet programmer\operator, I suggest going with water over laser. the cut will be much cleaner and you wont lose any strength due to the heat cutting (like you would with a laser). you won't have any potential warping either. bummer is waterjet is hella expensive. the place I worked at wouldn't even take in a job unless it had a $500 minimum cost. buy in bulk folks! |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|