| Slant Six Forum https://slantsix.org/forum/ |
|
| 7 1/4 plug? torx? https://slantsix.org/forum/viewtopic.php?t=16135 |
Page 1 of 1 |
| Author: | dookdart [ Sat Feb 11, 2006 1:00 pm ] |
| Post subject: | 7 1/4 plug? torx? |
75 7.25 rear. The diff cover drain plug seems to be a very large torx (#70?) anyone know what size? is this stock item? thx |
|
| Author: | dakight [ Sat Feb 11, 2006 2:11 pm ] |
| Post subject: | |
As I recall, the square drive of a 1/2" ratchet or breaker bar will fit it. It's been a long time since I've had occasion to take one out but I think that's what i used to do. |
|
| Author: | HyperValiant [ Sat Feb 11, 2006 2:13 pm ] |
| Post subject: | |
I used a 60 Torx driver on my 60 Valiant, HyperValiant |
|
| Author: | emsvitil [ Sat Feb 11, 2006 2:20 pm ] |
| Post subject: | |
I didn't think they had torx bits that far back............ |
|
| Author: | Slanted Opinion [ Sat Feb 11, 2006 3:16 pm ] |
| Post subject: | |
Yep, you can use the 1/2 ratchet, or with an extension. Fits perfectly. -Mac |
|
| Author: | SlantSixDan [ Sat Feb 11, 2006 3:19 pm ] |
| Post subject: | |
Or if you haven't got a ½"-drive ratchet handy, next time you're at the hardware store grab a ½" square by 3" piece of bar stock and toss it in your toolbox. |
|
| Author: | HyperValiant [ Sun Feb 12, 2006 12:19 pm ] |
| Post subject: | |
My 60 and 61 Valiants had the large Torx plug in them,,,yes I thought it was strange too,but thats what was there. HyperValiant |
|
| Author: | SlantSixDan [ Sun Feb 12, 2006 1:11 pm ] |
| Post subject: | |
They are not Torx-head plugs. Torx heads have six flutes; the plug under discussion is a double-square (8-point) socket head plug. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|