| Slant Six Forum https://slantsix.org/forum/ |
|
| Lower control arms at different angles - which one is bent? https://slantsix.org/forum/viewtopic.php?t=17095 |
Page 1 of 1 |
| Author: | sixsignet [ Sun Apr 16, 2006 2:55 pm ] |
| Post subject: | Lower control arms at different angles - which one is bent? |
If I put straight edges (parallel to driveshaft) on the bottom of both LCAs, they are at different angles. I suspect one is bent, but which one? Is there some measurement I can make to determine which one is bent? Is there some reference line the straight edges should be parallel to? Driveability seems fine. I am getting ready to rebuild the front end and want to replace any bent stuff... |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|