Slant Six Forum
https://slantsix.org/forum/

Rebuilding 7 1/4 Rear End
https://slantsix.org/forum/viewtopic.php?t=17466		 Page 1 of 1
Author:  69valiant [ Mon May 08, 2006 7:58 am ]
Post subject:  Rebuilding 7 1/4 Rear End
Ok, I have a 69 Valiant with a /6 225, 3 spd a745 manual trans, and a 7 1/4 rear end. I need to know what is involved in replacing the axle bearings and seals. Is this something I can do in my garage or is it just best to bring it to a shop. The reason I ask is that I've heard there will be some difficult extracting and pressing involved that I just don't have the proper tools for. The other thing is that it's my driver and I'd need to do this in pretty quick order. Rebuild or swap in a new one? Any feedback would be great. Thanks as always!!!!!!!!!!
Author:  terryx [ Mon May 08, 2006 8:02 am ]
Post subject:  meeee tooooo
HI

I am in exactally the same positon as you.

I put synthetic oil in my rear end and it leaked out the front seal

Now the front bearings are shot and makeing noise

I have a 67 dart with the 7 1/4 pumpking

maybe someone can advise us good :shock:


I would also like to know what is the NUMBER stamped on that front bearing so I can order up replacements, if anyone knows. I thing there are 2 bearings inner front and outer front....here's hoping
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/