| Slant Six Forum https://slantsix.org/forum/ |
|
| D100 - Replacing rear pads, no slack adjst'r https://slantsix.org/forum/viewtopic.php?t=19663 |
Page 1 of 1 |
| Author: | Highway [ Wed Sep 13, 2006 8:35 am ] |
| Post subject: | D100 - Replacing rear pads, no slack adjst'r |
I'm replacing the rear pads on my 85' D100. Problem I ran into was there is no "nipple" on the new pads for my automatic slack adjust "cam". I looked in my hardware kit didn't see anything. Has anybody ran into this problem, if so what was the fix? I don't mind adjusting my brakes periodically but it would be nice if the auto slack adjusters worked. Thanks |
|
| Author: | Eric W [ Wed Sep 13, 2006 9:49 am ] |
| Post subject: | |
Pound out the old pin, put it in your new shoes. Put a socket under the pin when you drive it out (using a punch). Use a C clamp or vise to reinstall. |
|
| Author: | Highway [ Wed Sep 13, 2006 1:17 pm ] |
| Post subject: | |
Thanks Eric, I'll give that a try. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|