Sorry guys if this has been covered before, I was wondering what intake this is??? I'm assuming it's not an Offy...
| Slant Six Forum https://slantsix.org/forum/ |
|
| What intake is this? https://slantsix.org/forum/viewtopic.php?t=19686 |
Page 1 of 1 |
| Author: | plymouthfan [ Thu Sep 14, 2006 9:07 am ] |
| Post subject: | What intake is this? |
Sorry guys if this has been covered before, I was wondering what intake this is??? I'm assuming it's not an Offy...
|
|
| Author: | CStryker [ Thu Sep 14, 2006 9:40 am ] |
| Post subject: | |
That appears to be one of the Hyperpack reproductions made by Clifford. |
|
| Author: | plymouthfan [ Thu Sep 14, 2006 9:51 am ] |
| Post subject: | |
Hmmm, their site doesn't seem to be up any more... is there a new adress? http://cliffordperformanceshop.com/site04/home.htm |
|
| Author: | CStryker [ Thu Sep 14, 2006 9:58 am ] |
| Post subject: | |
Yep. Do a little browsing around the site though before you think about ordering directly from Clifford. There are /numerous/ horror stories. |
|
| Author: | sick6 [ Thu Sep 14, 2006 10:00 am ] |
| Post subject: | |
that address is the old ordering site. the new site is http://cliffordperformance.net/ |
|
| Author: | starion88esir [ Thu Sep 14, 2006 12:21 pm ] |
| Post subject: | |
How is the quality of thier intake? Would there be a better one to look at getting? (looking for reliablity as well as power) |
|
| Author: | Bohmer2 [ Thu Sep 14, 2006 1:09 pm ] |
| Post subject: | |
Both clifford and offy have four barrel manifolds that would probably be better for fuel distribution than a hyperpack (long runners on hyperpack make for some issues, plus it causes interference issues on some vehicles because of how far it sticks out). There are also several other options out there including dual two barrel or single barrel carb manifolds, triple webber manifolds that can be found on ebay everyonce in a while. Reliability and performance various so widely it is hard to rate without knowing what your goals are and how your engine is currently setup? And of course there are lots of opinions on what is better but I find it something along these lines for performance. The carb and intake manifolds also need to be matched to other changes such as cam, head work, etc. Stock single barrel holley < Super six setup < proline dual setup < MPEFI offy |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|