OK thank you They told me that they didnot have a pin that big. So I am in the clear then. I was about to have a heart a tack.
| Slant Six Forum https://slantsix.org/forum/ |
|
| just got pistions. I think they #%$^ up https://slantsix.org/forum/viewtopic.php?t=19904 |
Page 1 of 1 |
| Author: | stolan83 [ Wed Sep 27, 2006 6:30 pm ] |
| Post subject: | just got pistions. I think they #%$^ up |
Just got my pistions from Venolia and was going over the data sheet and I think they ^&*( up on the pin bore they went .0901. Is that ok or is that .001 go to make impassable to get a pin with out having them made? |
|
| Author: | Joshie225 [ Wed Sep 27, 2006 6:51 pm ] |
| Post subject: | |
The pin itself is supposed to be .9012". The pin hole obviously has to be larger. When I spoke with Venolia they told me that if I didn't order pins (I did) the pistons would need to be honed by my machinist to fit the stock pins. |
|
| Author: | stolan83 [ Wed Sep 27, 2006 7:01 pm ] |
| Post subject: | |
OK thank you They told me that they didnot have a pin that big. So I am in the clear then. I was about to have a heart a tack.
|
|
| Author: | LUCKY13 [ Thu Sep 28, 2006 12:44 am ] |
| Post subject: | |
If you dont mind how much is a set a Venolias these days. Jess |
|
| Author: | Joshie225 [ Thu Sep 28, 2006 1:10 am ] |
| Post subject: | |
My set with pin oilers, .875" tapered wall 4340 wrist pins, pin fitting and double spirolocks was just over $500 shipped. The slugs are only $54.40 each. |
|
| Page 1 of 1 | All times are UTC-07:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|