I'm not sure that's so...my recollection is that the ELB sees manifold vacuum, while the distributor vacuum advance wants to ssee ported vacuum. I don't think carbs originally used with ELB have ported vacuum available.
| Slant Six Forum https://slantsix.org/forum/ |
|
| Ready to do ELB removal https://slantsix.org/forum/viewtopic.php?t=21175 |
Page 1 of 1 |
| Author: | 83miser [ Thu Dec 21, 2006 12:06 pm ] |
| Post subject: | Ready to do ELB removal |
I have New/Rebuilt Distributor and 4 pin module along with single ballast resistor. I intend to make the harness, As it appears very simple with a correct schematic. Once satisfied with results I want to remove anything unnecessary. I also will post a pic of Carter 2bbl in another topic for advice on it. Where should the Dist Vac connect? Any comments or advice is appreciated. |
|
| Author: | CStryker [ Thu Dec 21, 2006 1:44 pm ] |
| Post subject: | |
Iirc, it's the same port that the vacuum pod on the ELB connected to. |
|
| Author: | SlantSixDan [ Thu Dec 21, 2006 5:46 pm ] |
| Post subject: | |
I'm not sure that's so...my recollection is that the ELB sees manifold vacuum, while the distributor vacuum advance wants to ssee ported vacuum. I don't think carbs originally used with ELB have ported vacuum available.
|
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|