just got my valves, had to order them through a good mopar racer who was set up for paypal, only took 3wks with ground usps&can post,the valves look really nice and only $80loonies to here,so i am going to do a fresh head and block for blower motor, after what i put this engine through i am going to make it my new backup,it still starts and runs but after 5 blown head gasket and 3sets of cooked rings its time to make my new tuneup on a fresh motor or thats the plan so far

Just sayin hey from St. John's

Also I was thinking about picking up some of these engnbldr valves when I get the cash as well.

hello, nice to hear a voice close to home ,were are you in town?there nice valves hope they flow as well as the 318 ones that i am using now,you can`t beat the price

I just got mine (1.70" X 1.44") UPS Wednesday.
LOOK great so far, but still have to get the head and these beauties to my Windsor (Ont.) engine builder for the instal.
Then I have been in touch with the BMW America (Inline engine racing) cylinder head GURU in New Jersey (Jim Furdyn) to take a few liberties with my Slant's head, following their years of Porting Technology.
Hope for the best.
Terry

_________________
Terry Bogusz
From Super 6 Left turns to Straight again.

must be a good shop if your sending you parts up north,over here were lucky the shop knows what a 3 angle valve job is but they are learning